THE LAYERED STRUCTURE OF COMPOSITE MATERIALS BASED ON NIOBIUM ALLOY OBTAINED BY THE SOLID-PHASE TECHNOLOGY
Valery P. Korzhov
Strony: 196-208
Opublikowano: 31 May 2015
Wyświetlenia: 3,662
Pobrania: 911
Streszczenie: The methods of diffusion welding and pack rolling in two cycles experimental samples were made of composite materials, differing in functional properties: the superconducting multilayer tape based alloy Nb-50Ti, stabilized with copper and refractory material with a layered structure. From the X-ray spectral analysis concluded that interdiffusion between the layers in multilayer composites with the formation of expected alloys and chemical compounds occurred mainly due to the diffusion of niobium and carbon. Due to the high mobility of atomic carbon was able to penetrate all the structural components of the composite and to form the reinforcing phase in the form of carbide precipitates and layers of silicon-carbon chemical compound.
Słowa kluczowe: composite, solid-phase reaction, superconducting material, niobium-titanium alloy, heat-resistant material, diffusion welding, layered structure
Cytowanie artykułu: Valery P. Korzhov. THE LAYERED STRUCTURE OF COMPOSITE MATERIALS BASED ON NIOBIUM ALLOY OBTAINED BY THE SOLID-PHASE TECHNOLOGY. Journal of International Scientific Publications: Materials, Methods & Technologies 9, 196-208 (2015). https://www.scientific-publications.net/en/article/1000766/
Powrót do spisu treści tomu
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
