EFFECT OF SINTERING TEMPERATURE ON DIELECTRIC PROPERTIES OF SIO2 DOPED BATIO3 CERAMICS
Kerim Emre Öksüz, Merve Torman, Şaduman Şen, Uğur Şen
Strony: 361-366
Opublikowano: 10 Jul 2016
Wyświetlenia: 2,426
Pobrania: 561
Streszczenie: SiO2-doped BaTiO3 ceramics were prepared by solid state mixed oxide technique. The effect of small amounts (0.3 mol %) of SiO2 additive on the microstructure, sintering behavior and dielectric properties of BaTiO3-based ceramics have been investigated. SiO2-doped BaTiO3 ceramics sintered at 1175°C, 1200°C and 1225°C for 4h in air atmosphere have been found to exhibit high density and a uniform grain size. A scanning electron microscopy, X-ray diffraction analysis and LCR meters have been used to determine the microstructure, phase analysis and dielectric properties of the SiO2 doped BaTiO3 ceramics. The SiO2 can form a liquid phase belonging to the ternary system BaO-TiO2-SiO2, leading to the formation of BaTiO3 ceramics with high density at the lower sintering temperature, and improves the sintering and dielectric properties of BaTiO3-based ceramics.
Słowa kluczowe: barium titanate, dielectric properties, microstructure, sintering, sio2
Cytowanie artykułu: Kerim Emre Öksüz, Merve Torman, Şaduman Şen, Uğur Şen. EFFECT OF SINTERING TEMPERATURE ON DIELECTRIC PROPERTIES OF SIO2 DOPED BATIO3 CERAMICS. Journal of International Scientific Publications: Materials, Methods & Technologies 10, 361-366 (2016). https://www.scientific-publications.net/en/article/1001159/
Powrót do spisu treści tomu
© 2025 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
