MICROSTRUCTURE AND MECHANICAL PROPERTIES OF HEAT TREATED SELECTIVE LASER MELTING MANUFACTURED TI-6AL-4V
Denis David Malka-Markovitz, Alexander Katsman, Amnon Shirizly, Menahem Bamberger
Strony: 495-505
Opublikowano: 11 Jul 2016
Wyświetlenia: 2,780
Pobrania: 720
Citations: 2 (Google Scholar)
Citations: 2 (OpenAlex)
Streszczenie: Investigation of microstructural evolution of pre and post heat treatment (HT) Selective Laser Melting (SLM) Ti-6Al-4V is presented. As received SLM samples composed of fine acicular α martensite with prior β grains were solution treated above β-transus temperature, followed by a complementary HT within the α+β range. Non-monotonic change of microhardness as a function of HT temperature was observed. After low HT temperatures, the microstructure was composed mainly of martensitic α′ phase, whereas, after high temperatures HT, bi-phasic microstructure with needle-like elongated α-phase grains and a mixture of lamellar α+β in between, was observed as the dominant microstructural component. The dependence of the properties and microstructure on heat treatment temperature will be discussed.
Słowa kluczowe: slm, ti-6al-4v, microstructure, thermal treatments, mechanical properties
Cytowanie artykułu: Denis David Malka-Markovitz, Alexander Katsman, Amnon Shirizly, Menahem Bamberger. MICROSTRUCTURE AND MECHANICAL PROPERTIES OF HEAT TREATED SELECTIVE LASER MELTING MANUFACTURED TI-6AL-4V. Journal of International Scientific Publications: Materials, Methods & Technologies 10, 495-505 (2016). https://www.scientific-publications.net/en/article/1001172/
Powrót do spisu treści tomu
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
