DEVELOPMENT AND CHARACTERIZATION OF CHITOSAN HYBRID COATINGS BY SOL-GEL METHOD
Rosa Taurino, Stefano Caporali, Francesca Borgioli, Emanuele Galvanetto
Strony: 34-41
Opublikowano: 30 Nov 2023
DOI: 10.62991/MMT1996345835
Wyświetlenia: 552
Pobrania: 59
Streszczenie: This paper describes the preparation and characterization of hybrid coatings constituted by SiO2, TiO2 and chitosan in varying compositions on aluminium, and glass substrates by sol–gel method. The optimized sol-gel solutions were deposited using by dip-coating and spray coating and the thermal treatment conditions (temperature) were optimized. In particular, condensation reactions necessary to allow the formation of the metal oxide networks were performed by storing the films in an open-air oven at 100°C and 80 °C for 30 minutes. Moreover, the functionalization of hybrid has been carried out with vinyltrimethoxysilane (VTMS). The films were investigated by scanning electron microscopy (SEM), Fourier transformed infrared (FTIR) spectroscopy, hydrolytic degradation, corrosion resistance and adhesion test. The process yields transparent chitosan hybrid coatings with good adhesion on glass and aluminium substrates. The obtained results suggest that the functionalization of the hybrid coatings was affected through in situ hydrolysis–condensation reaction of vinyltrimethoxysilane (VTMS) in the reaction medium.
Słowa kluczowe: sol-gel process, chitosan, hybrid, corrosion
Cytowanie artykułu: Rosa Taurino, Stefano Caporali, Francesca Borgioli, Emanuele Galvanetto. DEVELOPMENT AND CHARACTERIZATION OF CHITOSAN HYBRID COATINGS BY SOL-GEL METHOD. Journal of International Scientific Publications: Materials, Methods & Technologies 17, 34-41 (2023). https://doi.org/10.62991/MMT1996345835
Powrót do spisu treści tomu
© 2025 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
