METHOD FOR EVALUATING THE DURABILITY OF MOULD SLEEVES FOR HIGHPRESSURE DIE CASTING OF AL IN MELT
Janette Brezinová, Miroslav Džupon, Ján Viňáš, Jakub Brezina
Strony: 1-9
Otrzymano: 31 Jul 2024
Opublikowano: 17 Dec 2024
DOI: 10.62991/MMT1996568827
Wyświetlenia: 1,494
Pobrania: 274
Streszczenie: The paper presents the results of research aimed at determining the quality of renovation layers for the restoration of shaped parts of molds for high-pressure casting of aluminum alloys. An analysis of the wear of the shaped parts of the mold was carried out and the dominant degradation mechanisms were identified. A method of modifying the surface of the shaped parts of the molds by creating a stochastic texture with a low-energy laser in combination with duplex PVD coatings on the surfaces of the parts of the molds that are in contact with the molten aluminum alloy was proposed and verified. The methodology of measuring the contact angle for determining the number of sprays with a separating agent - lubricant on the surface of a new or of the renovated shaped part of the mold before the first casting cycle. Dievar, Dratec, UTPA 702 additional materials were verified for the creation of renovation layers. PVD coatings were applied to increase the durability of the layers. The coefficient of corrosion resistance of clads in aluminum alloy was determined.
Słowa kluczowe: laser, cladding, layers, dievar, dratec, utpa 702, surface texturing
Cytowanie artykułu: Janette Brezinová, Miroslav Džupon, Ján Viňáš, Jakub Brezina. METHOD FOR EVALUATING THE DURABILITY OF MOULD SLEEVES FOR HIGHPRESSURE DIE CASTING OF AL IN MELT. Journal of International Scientific Publications: Materials, Methods & Technologies 18, 1-9 (2024). https://doi.org/10.62991/MMT1996568827
Powrót do spisu treści tomu
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
