INCREASING OF THE CUTTING POWER AT INSERTS FOR APPLICATION IN THE AREA OF POWER INDUSTRY
Jaroslava Fulemova, Zdenek Janda
Strony: 283-292
Opublikowano: 1 Jan 2013
Wyświetlenia: 235
Pobrania: 29
Streszczenie: This article deals with the influence of cutting edge preparation on tool life, cutting forces and the roughness of machined surface. The cutting edge preparation was done on the inserts with wiper geometry which are used during machining of dividing plane at a steam turbine casing. This cutting inserts were prepared by the technology of drag finishing on the edge radius 5, 10 and 15ȝm. The workpiece material was ferritic – martensitic steel with the content of 9%Mo and 1%Cr and the material of cutting inserts was submicron sintered carbide. There was used only one cutting insert in the milling cutter.
Słowa kluczowe: edge radius, milling, tool life, roughness, forces
Cytowanie artykułu: Jaroslava Fulemova, Zdenek Janda. INCREASING OF THE CUTTING POWER AT INSERTS FOR APPLICATION IN THE AREA OF POWER INDUSTRY. Journal of International Scientific Publications: Materials, Methods & Technologies 7, 283-292 (2013). https://www.scientific-publications.net/en/article/1003059/
Powrót do spisu treści tomu
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
