STRESS-STRAIN STATE OF MILL FOR COLD ROLLING OF TUBES
Konstantin A. Goncharov, Yuri B. Chechulin
Strony: 222-229
Opublikowano: 1 Jan 2011
Wyświetlenia: 83
Streszczenie: The stress-strain state of construction of the cold rolling mill for large diameter tubes was investigated. Mathematical model based on the use of numerical finite element method, and the special element, which is located on contact surface, is used to simulate the contact interaction. Computer simulation based on the proposed model allowed us to establish the causes of extremely low durability bearing and offer a fundamentally new solution, which enables in multiple times to increase uptime of the roll mill.
Słowa kluczowe: rolling mill, work roll, bearing, caliber, nonlinear problem, computer simulation
Cytowanie artykułu: Konstantin A. Goncharov, Yuri B. Chechulin. STRESS-STRAIN STATE OF MILL FOR COLD ROLLING OF TUBES. Journal of International Scientific Publications: Materials, Methods & Technologies 5, 222-229 (2011). https://www.scientific-publications.net/en/article/1003300/
Powrót do spisu treści tomu
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
