EQUILIBRIUM BORON DISTRIBUTION BETWEEN FE–C–SI–AL MELT AND BORON-BEARING SLAG
Anatoly A. Babenko, Leonid A. Smirnov, Alena G. Upolovnikova
Pagini: 202-208
Publicat: 6 Sep 2018
Vizualizări: 1,861
Descărcări: 259
Rezumat: HSC 6.1 Chemistry software (Outokumpu) and a simplex–lattice experiment design are employed in thermodynamic modeling of the equilibrium boron distribution between steel containing 0.1% C, 0.54% Si, and 0.01% Al (wt % are used throughout) and CaO–SiO2–B2O3–25%Al2O3–8%MgO slag over a broad range of chemical composition at 1500 and 1600°C. For each temperature, mathematical models (in the form of a reduced third-order polynomial) are obtained for the equilibrium boron distribution between the slag and the molten metal as a function of the slag composition. The results of simulation are presented as graphs of the composition and equilibrium distribution of boron. The slag basicity has considerable influence on the distribution coefficient of boron. Experimental data practically confirm the results of thermodynamic modeling.
Cuvinte cheie: boron, steel, slag, interphase distribution, thermodynamic modeling, diagrams
Citează acest articol: Anatoly A. Babenko, Leonid A. Smirnov, Alena G. Upolovnikova. EQUILIBRIUM BORON DISTRIBUTION BETWEEN FE–C–SI–AL MELT AND BORON-BEARING SLAG. Journal of International Scientific Publications: Materials, Methods & Technologies 12, 202-208 (2018). https://www.scientific-publications.net/en/article/1001698/
Înapoi la cuprinsul volumului
© 2025 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
