COMPATIBILITY STUDY OF ETHYLENE ACRYLIC DIPOLYMER / ETHYLENE PROPYLENE DIENE TERPOLYMER RUBBER BLENDS WITH A HOMOGENIZING AGENT
Ünal G., Ersoy Meriçboyu A.
Pagini: 153-162
Publicat: 18 Sep 2019
Vizualizări: 1,871
Descărcări: 169
Rezumat: The effects of the homogenizer type and amount on cure characteristics, mechanical properties and thermal stabilities of the AEM (Ethylene acrylic dipolymer)/EPDM(Ethylene propylene diene terpolymer) blends were investigated. To observe the effect of the homogenizer incorporation, mechanical properties of the blends were determined under thermally aged conditions at two different temperatures of 160°C and 180°C. Experimental results showed that, the amount of homogenizer has a major effect on mechanical properties of all blend ratios. Although the addition of 5 phr homogenizer caused an increase in the thermal stabilities of the blends, the addition of 10 phr homogenizer resulted in a decrease in the thermal stabilities of the blends at both temperatures. These findings were further supported by the Differential Scanning Calorimetry (DSC) analysis.
Cuvinte cheie: polymer blends, rubbers, compatibility, homogenizer
Citează acest articol: Ünal G., Ersoy Meriçboyu A.. COMPATIBILITY STUDY OF ETHYLENE ACRYLIC DIPOLYMER / ETHYLENE PROPYLENE DIENE TERPOLYMER RUBBER BLENDS WITH A HOMOGENIZING AGENT. Journal of International Scientific Publications: Materials, Methods & Technologies 13, 153-162 (2019). https://www.scientific-publications.net/en/article/1001890/
Înapoi la cuprinsul volumului
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
