EVALUATION OF 4D PRINTED PBS, PBS/HA USING PAM PROCESS
Conrad Mastalerz, Isabelle Vroman, Pierre Millet, Xavier Coqueret, Marie Dubus, Halima Kerdjoudj, Sébastien Alix
Pagini: 68-77
Publicat: 23 Sep 2021
Vizualizări: 842
Descărcări: 115
Rezumat: Polybutylene succinate (PBS) was used in this study to evaluate its capability to ensure properties of an implanting scaffold. PBS was mixed with an inorganic filler; hydroxyapatite (HA) which is a component of natural bone to enhance cell viability. Biocomposites were prepared using melt extrusion process, trying to obtain the highest filler ratio. Compounds were then shaped using Fused Filament Fabrication (FFF) and Pellet Additive Manufactuing (PAM) which allowed to print biocomposites with high filler ratio. 3D specimens showed an increase in elastic properties with radiation dose due to crosslinking reaction in PBS, but a decrease on the elongation at break with the predominance of chain scission at higher radiation dose. Moreover, PAM process permitted to print biocomposites with a filler ratio of HA up to 40% (w/w). 4D printing of biomaterials using electron beam irradiations looks promising for bone tissue engineering.
Cuvinte cheie: 4d printing, bone tissue engineering, electron beam irradiations, pellet additive manufacturing pam
Citează acest articol: Conrad Mastalerz, Isabelle Vroman, Pierre Millet, Xavier Coqueret, Marie Dubus, Halima Kerdjoudj, Sébastien Alix. EVALUATION OF 4D PRINTED PBS, PBS/HA USING PAM PROCESS. Journal of International Scientific Publications: Materials, Methods & Technologies 15, 68-77 (2021). https://www.scientific-publications.net/en/article/1002199/
Înapoi la cuprinsul volumului
© 2025 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
