INFLUENCE OF EXTRUSION PARAMETERS ON SIC DISTRIBUTION AND PROPERTIES OF AA6061/SIC COMPOSITES PRODUCED BY KOBO METHOD
Jaroslaw Wozniak, Marek Kostecki, Kamil Broniszewski, Wlodzimierz Bochniak, Andrzej Olszyna
Pagini: 293-304
Publicat: 1 Jan 2013
Vizualizări: 244
Descărcări: 24
Rezumat: The influence of extrusion parameters on reinforcements distribution and properties of AA6061+x% vol. SiCp (x=0; 2.5; 5; 7.5; 10) composites was discussed in this paper The averages size of AA6061 and SiC particles were 10.6 um and 0.42 um, respectively. The composites were consolidated via powder metallurgy processing (without the sintering) and extruded by KoBo method. The microstructure was examined on each steps of production. High values of density for all produced composites were achieved. Additionally, hardness and Young’s modulus were investigated. The best reinforcement distribution and mechanical properties were obtained for composites extruded with the highest extrusion ratio.
Cuvinte cheie: aluminum alloy, extrusion, aged hardening, metal matrix composites, microstructure
Citează acest articol: Jaroslaw Wozniak, Marek Kostecki, Kamil Broniszewski, Wlodzimierz Bochniak, Andrzej Olszyna. INFLUENCE OF EXTRUSION PARAMETERS ON SIC DISTRIBUTION AND PROPERTIES OF AA6061/SIC COMPOSITES PRODUCED BY KOBO METHOD. Journal of International Scientific Publications: Materials, Methods & Technologies 7, 293-304 (2013). https://www.scientific-publications.net/en/article/1003060/
Înapoi la cuprinsul volumului
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
