MICROSTRUCTURE AND ELECTRICAL PROPERTIES OF MULTILAYER VARISTORS BASED ON DOPED ZINC OXIDE
Jan Kulawik, Dorota Szwagierczak, Bohdan Rusiecki, Barbara Gröger
Pagini: 321-331
Publicat: 1 Jan 2012
Vizualizări: 286
Descărcări: 27
Rezumat: The paper presents fabrication procedure, microstructure and electrical properties of multilayer varistors based on ZnO doped with Bi, Sb, Co, Mn, B, Si and Pr oxides. Tape casting technique was used for preparation of flexible ceramic tapes 100 Pm thick. A slurry for tape casting was prepared by binder, fish oil as a dispersant, polyethylene glycol and dibutyl phthalate as plasticizers, toluene and isopropyl alcohol as solvents. Green sheets with screen-printed Pt electrodes were stacked, pressed isostatically and cosintered at 1050°C. The microstructure and the distribution of elements inside multilayer varistors were studied using scanning electron microscopy and energy dispersive spectroscopy. Current-voltage characteristics of multilayer varistors were determined. The investigated varistors exhibit a high nonlinearity coefficient of 25-28 and a breakdown voltage of 60- 80 V.
Cuvinte cheie: multilayer varistor, doped zno, tape casting, nonlinearity coefficient
Citează acest articol: Jan Kulawik, Dorota Szwagierczak, Bohdan Rusiecki, Barbara Gröger. MICROSTRUCTURE AND ELECTRICAL PROPERTIES OF MULTILAYER VARISTORS BASED ON DOPED ZINC OXIDE. Journal of International Scientific Publications: Materials, Methods & Technologies 6, 321-331 (2012). https://www.scientific-publications.net/en/article/1003181/
Înapoi la cuprinsul volumului
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
