CHANGES IN MICROSTRUCTURE AND MICROHARDNESS AFTER APPLICATION OF UNCONVENTIONAL CUTTING TECHNOLOGIES ON ARMOURED STEELS
Igor Barényi, Ondrej Híreš, Peter Lipták, Martin Hládek
Pages: 249-255
Published: 1 Jan 2011
Views: 85
Abstract: The paper describes changes appeared in microstructure and microhardness of selected Armox steels after their cutting by unconventional technologies as are plasma, laser and water jet cutting. Three variants of ARMOX steels (440, 500 and 600) were cut with using of stated methods and then tested by Vickers microhardness test and examined their micro structure. Finally, the results are compared and evaluated to formulate conclusions.
Keywords: armour steels, armox, plasma cutting, laser cutting, water jet cutting, microhardness
Cite this article: Igor Barényi, Ondrej Híreš, Peter Lipták, Martin Hládek. CHANGES IN MICROSTRUCTURE AND MICROHARDNESS AFTER APPLICATION OF UNCONVENTIONAL CUTTING TECHNOLOGIES ON ARMOURED STEELS. Journal of International Scientific Publications: Materials, Methods & Technologies 5, 249-255 (2011). https://www.scientific-publications.net/en/article/1003303/
Back to the contents of the volume
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
