AL2O3-NI COMPOSITES FOR CUTTING TOOLS
Kamil Broniszewski, Jaroslaw Wozniak, Marek Kostecki, Kazimierz Czechowski, Lucyna Jaworska, Andrzej Olszyna
Страници: 321-328
Публикувана: 1 Jan 2013
Преглеждания: 633
Изтегляния: 94
Резюме: The main disadvantage of ceramic cutting tools is their low fracture toughness that leads to a chipping and cracking of ceramic edges during machining process. It is believed that addition of metal particles would increase the K ICparameter of ceramic matrix composites. In present work basic mechanical properties of Al2O3-x%wt.Ni composites were examined. A cutting tools life and surface roughness parameter were defined in dry machining of hardened steel tests. The possible reactions between cutting tool edge and machined material were also investigated as any chemical reaction can lead to increase of tools wear ratio. Density and porosity of produced composites were measured with the use of Archimedes method. Phase analysis was carried out on an X-ray diffractometer. The microstructure observation was performed on an optic microscope. Fracture toughness was measured with the use of the Vickers indentation method.
Ключови думи: alumina, composites, cutting tools, nickel
Цитирайте тази статия: Kamil Broniszewski, Jaroslaw Wozniak, Marek Kostecki, Kazimierz Czechowski, Lucyna Jaworska, Andrzej Olszyna. AL2O3-NI COMPOSITES FOR CUTTING TOOLS. Journal of International Scientific Publications: Materials, Methods & Technologies 7, 321-328 (2013). https://www.scientific-publications.net/en/article/1003063/
Обратно към съдържанието на тома
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
