MEASUREMENTS USING THE STRAIN GAGE ROSETTE IN INJECTION MOLDED POLYMERIC PARTS
Alexandra Niţă, Bogdan Leiţoiu, Viorel Goanţă, Paul Bârsănescu
Страници: 34-45
Публикувана: 1 Jan 2009
Преглеждания: 363
Изтегляния: 51
Резюме: The characterization of plastics for engineering purposes necessitates considerably testing than is typical for metals primarily because of time, temperature, moisture, and aging effects on the material behavior. With the increasing number of plastic structural components, it can be expected that the need to measure service strains on these materials will increase correspondingly and the strain gage application technology must be advanced accordingly. It is very important for polymeric materials to determine the Young’s modulus and the Poisson’s ratio using the strain gage rosette. This paper presents the measurements using the strain gage rosette on three different used plastics: ABS, PP and PS. The strain measurement on a plastic or composite test object will frequently call for much greater skill, expertise, and knowledge of mechanics than that typically required with the structural metals.
Ключови думи: polymeric material, strain gage rosette, elastic constants
Цитирайте тази статия: Alexandra Niţă, Bogdan Leiţoiu, Viorel Goanţă, Paul Bârsănescu. MEASUREMENTS USING THE STRAIN GAGE ROSETTE IN INJECTION MOLDED POLYMERIC PARTS. Journal of International Scientific Publications: Materials, Methods & Technologies 3, 34-45 (2009). https://www.scientific-publications.net/en/article/1003460/
Обратно към съдържанието на тома
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
