INVESTIGATION OF FACTORS HAVING EFFECT ON DEFORMATION IN DRILLING OF GLASS FIBER REINFORCED COMPOSITE MATERIALS
Yahya Hışman Çeli̇k, İhsan Pi̇lati̇n
Pages: 328-337
Published: 1 Jan 2013
Views: 339
Downloads: 21
Abstract: Glass fiber reinforced plastic (GFRP) composite materials are used in various fields because of their superior properties. The drilling process is the method mostly used in processing GFRP composites in chipping form. Since they are hard and abrasive, there appear problems in drilling these materials. The damages in entrance and exit of the holes are the most important of these problems. Therefore, in this study, drilling of GFRP composite material produced via lay-up method was executed at the cutting speeds of 60, 90 and 120 m/min; and at feed rate values of 100, 200 and 300 mm/min; and by o o o means of drill at 4, 7, 10 mm possessing point angles 90 , 118 and 140 without using cutting fluid. Depending on the damage in entrance and exit of the holes, deformation factor was calculated. It was observed that the damage occurring in the exit of the holes was greater than that of the entrance of the holes. It was found out that the minimum deformation occurred at low cutting speed and feed rates.
Keywords: gfrp, composites, drilling, surface roughness, deformation
Cite this article: Yahya Hışman Çeli̇k, İhsan Pi̇lati̇n. INVESTIGATION OF FACTORS HAVING EFFECT ON DEFORMATION IN DRILLING OF GLASS FIBER REINFORCED COMPOSITE MATERIALS. Journal of International Scientific Publications: Materials, Methods & Technologies 7, 328-337 (2013). https://www.scientific-publications.net/en/article/1003114/
Back to the contents of the volume
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
