SURFACE MODIFICATION OF POLYETHYLENE TEREPHTHALATE SUBSTRATES BY HIGH FREQUENCY AIR DISCHARGE PLASMA. STRUCTURE, MORFOLOGY, ADHESION PERFORMANCE
Anna A. Shcherbina, Yuliya Yu. Gladkikh, Valentina Yu. Stepanenko, Yuliya V. Kostina, Anatoly E. Chalykh
Страници: 101-112
Публикувана: 1 Jan 2012
Преглеждания: 656
Изтегляния: 79
Резюме: Effect of high frequency air discharge plasma on the surface and adhesion performance of polyethylene terephthalate (PET) substrates of different thickness was investigated. Based upon X-ray photoelectron spectroscopy, contact angle measurements and ATF FTIR was shown that chemical composition of thin surface layer changes even after first 5 minutes of plasma treatment in spite of mild conditions of etching. Structure changes were estimated by AFM and TEM. It was shown that plasma treatment reveals phase structure organization of PET, but total surface relief changes insignificantly. Dramatic change in surface energy after treatment was revealed by contact angle measurements. At the same time, it was shown that surface energy relaxation occurs during storage of substrate in room conditions. These results are in good agreement with adhesion performance of PET substrate to model silicon scotch estimated by 180º Peel Test.
Ключови думи: surface energy, adhesion properties, plasma etching of pet surface
Цитирайте тази статия: Anna A. Shcherbina, Yuliya Yu. Gladkikh, Valentina Yu. Stepanenko, Yuliya V. Kostina, Anatoly E. Chalykh. SURFACE MODIFICATION OF POLYETHYLENE TEREPHTHALATE SUBSTRATES BY HIGH FREQUENCY AIR DISCHARGE PLASMA. STRUCTURE, MORFOLOGY, ADHESION PERFORMANCE. Journal of International Scientific Publications: Materials, Methods & Technologies 6, 101-112 (2012). https://www.scientific-publications.net/en/article/1003158/
Обратно към съдържанието на тома
© 2026 The Author(s). This is an open access article distributed under the terms of the
Creative Commons Attribution License https://creativecommons.org/licenses/by/4.0/, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. This permission does not cover any third party copyrighted material which may appear in the work requested.
Disclaimer: The Publisher and/or the editor(s) are not responsible for the statements, opinions, and data contained in any published works. These are solely the views of the individual author(s) and contributor(s). The Publisher and/or the editor(s) disclaim any liability for injury to individuals or property arising from the ideas, methods, instructions, or products mentioned in the content.
